en · de
epitalon-notes.peptides4800.com › Info › Epitalon Peptide Background And Structure — Worked Examples

Epitalon Peptide Background And Structure — Worked Examples

By Editorial Desk · published 2026-03-05 · last reviewed 2026-03-19 · Info

Everything below concerns Khavinson. We keep the language plain, cite what the science says, and separate well-supported claims from open questions.

Last reviewed on 2026-03-19. Where a claim depends on a specific study, the study is described rather than over-claimed.

Epitalon Peptide Background and Structure

Epitalon is a synthetic tetrapeptide with the amino acid sequence alanine-glutamate-aspartate-glycine, abbreviated Ala-Glu-Asp-Gly or AEDG. It was developed by the Russian researcher Vladimir Khavinson and colleagues during work on peptide bioregulators derived from the pineal gland. The compound is short enough to be produced by standard solid-phase peptide synthesis and is typically handled as a lyophilized white powder. Its small size distinguishes it from larger pineal peptides such as epithalamin, a complex extract from which the tetrapeptide was conceptually derived.

The four residues give epitalon a molecular formula of C14H22N4O9 and a molecular weight near 390.35 daltons. The presence of two acidic residues, glutamate and aspartate, makes the free peptide strongly acidic, while the alanine and glycine ends provide neutral, nonpolar character. This combination produces a molecule with substantial water solubility. Because there are no cysteine, methionine, or tryptophan residues, the peptide lacks the most common oxidation-sensitive side chains, which simplifies handling compared with many longer peptides.

Identity and Research Background

Epitalon is a synthetic tetrapeptide whose sequence is alanine–glutamate–aspartate–glycine, commonly abbreviated AEDG. It was developed in Russia during the 1980s and 1990s by investigators associated with the St. Petersburg Institute of Bioregulation and Gerontology, who studied short peptides as regulators of gene expression and tissue function. The alternative spelling epithalon appears interchangeably in the literature, and the two names refer to the same molecule. Outside Russia it is encountered chiefly as a research chemical rather than a licensed medicine, and it holds no approval from the United States Food and Drug Administration or the European Medicines Agency.

The peptide is a synthetic analogue of epithalamin, a preparation extracted from bovine pineal glands. Investigators sought a short, chemically defined molecule that would reproduce some of the endocrine and gerontological observations attributed to the glandular extract. Proposed mechanisms centre on induction of telomerase activity, an effect reported in cultured human somatic cells in the early 2000s, together with influences on melatonin secretion and neuroendocrine regulation. Those mechanisms remain incompletely characterised, and the reported telomerase response has not been consistently reproduced by independent groups working in comparable systems.

Epitalon at a glance

PropertyValueNotes
Amino acid sequenceAla-Glu-Asp-GlyTetrapeptide, often abbreviated AEDG
Molecular formulaC14H22N4O9Free peptide, unmodified termini
Molecular weight~390.35 DaCalculated for the free acid form
AppearanceWhite to off-white powderTypical lyophilized product form
Solubility classFreely soluble in waterTwo acidic residues dominate ionic character

Epitalon Background and Nomenclature

Epitalon is the common name for a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, usually abbreviated AEDG. All four residues are proteinogenic amino acids, and the free peptide has a calculated mass near 390 grams per mole. Because the chain is short and carries no modifications, it is assembled readily by solid-phase synthesis and is distributed mainly as a freeze-dried solid for laboratory work. Catalogue listings use the spellings epitalon, epithalone, and simply AEDG, and the three refer to the same sequence.

The compound is generally presented as a synthetic fragment of epithalamin, a pineal gland extract investigated in the former Soviet Union from the 1970s onward. Vladimir Khavinson and colleagues in Saint Petersburg developed short peptides modelled on such extracts, and epitalon became the most widely cited of those sequences. Most primary reports appeared in Russian-language journals or in proceedings with limited international circulation. Independent replication in laboratories outside that network remains sparse, and much repeated secondary material traces back to a small number of originating groups.

Related pages on this site

Background from the literature

White was married to his wife Edna for more than 40 years. He died unexpectedly on February 14, 1980, in Santa Barbara, California, where he had gone that day from his home in Palo Alto to deliver a lecture at the University of California. Several awards in the field of biochemistry have been named for White, including at Oakland University in Michigan, Wayne State University, George Washington University School of Medicine and the Gladstone Institutes. 1935 – Traveling Fellowship, American Physiological Society, for the XVth International Congress of Physiology (Leningrad and Moscow) 1938 – Eli Lilly Prize in Biochemistry 1960 – Distinguished Alumni Award, University of Denver 1967 – Sesquicentennial Alumni Award, University of Michigan 1969 – Borden Award, Association of American Medical Colleges 1959 – Doctor of Humane Letters, Yeshiva University 1975 – Doctor of Science, University of Denver

The above descriptions ignore the effects of Gβγ–signalling, which can also be important, in particular in the case of activated Gαi/o-coupled GPCRs. The primary effectors of Gβγ are various ion channels, such as G-protein-regulated inwardly rectifying K+ channels (GIRKs), P/Q- and N-type voltage-gated Ca2+ channels, as well as some isoforms of AC and PLC, along with some phosphoinositide-3-kinase (PI3K) isoforms.

The AToFMS allows for the determination of mixing state, or distribution of chemical species, within individual particles. These mixing states are important in the determination of climate and health impact of aerosols. The schematic of a typical AToFMS is shown to the right. The overall structure of ATOF instruments is; sampling, sizing, and the mass analyzer region. The inlet system is similar to the AMS by using the same aerodynamic focusing lens, but it has smaller orifices because of its analysis of single particles. In the sizing region particle passes through the first continuous solid state laser that generates an initial pulse of scattered light. Then the particle passes through the second laser that is orthogonal to the first and produces a pulse of scattered light. The light is detected by a photomultiplier (PMT) that is matched up to each laser. Using the transit times between the two detected pulses and the fixed distance the velocity and size of each particle is calculated. Next the particles travel through to the mass analyzer region where it is ionized by a pulsed LDI laser, which is timed to hit the particle as it reaches the center of the ion extraction region. Once ionized, the positive ions are accelerated towards the positive ToF section and the negative ions are accelerated towards the negative ToF section where they are detected.

Sources: en.wikipedia.org

Further detail

Temperature programmed desorption (TPD) is the method of observing desorbed molecules from a surface when the surface temperature is increased. When experiments are performed using well-defined surfaces of single-crystalline samples in a continuously pumped ultra-high vacuum (UHV) chamber, then this experimental technique is often also referred to as thermal desorption spectroscopy or thermal desorption spectrometry (TDS). When molecules or atoms come in contact with a surface, they adsorb onto it, minimizing their energy by forming a bond with the surface. The binding energy varies with the combination of the adsorbate and surface. If the surface is heated, at one point, the energy transferred to the adsorbed species will cause it to desorb. The temperature at which this happens is known as the desorption temperature. Thus TPD shows information on the binding energy.

Blood factors (Factor VIII and Factor IX) Thrombolytic agents (tissue plasminogen activator) Hormones (insulin, glucagon, growth hormone, gonadotrophins) Haematopoietic growth factors (Erythropoietin, colony-stimulating factors) Interferons (Interferons-α, -β, -γ) Interleukin-based products (Interleukin-2) Vaccines (Hepatitis B surface antigen) Monoclonal antibodies (Various) Additional products (tumour necrosis factor, therapeutic enzymes) Research and development investment in new medicines by the biopharmaceutical industry stood at $65.2 billion in 2008. A few examples of biologics made with recombinant DNA technology include: Many vaccines are grown in tissue cultures. Viral gene therapy involves artificially manipulating a virus to include a desirable piece of genetic material. Viral gene therapies using engineered plant viruses have been proposed to enhance crop performance and promote sustainable production.

3D cell culture methods have been developed to enable research into the behavior of cells in an environment that represents their interactions in-vivo more accurately. 3D cell culturing by magnetic levitation uses biocompatible polymer-based reagents to deliver magnetic nanoparticles to individual cells, so that an applied magnetic driver can levitate cells off the bottom of the cell culture dish, rapidly bringing cells together near the air-liquid interface. This act initiates cell-cell interactions in the absence of any artificial surface or matrix. Magnetic fields are designed to form 3D multicellular structures, including the expression of extracellular matrix proteins. The matrix, protein expression, and response to exogenous agents of the resulting tissue show similarity to in-vivo results. 3D cell culturing by magnetic levitation method (MLM) was developed with collaboration between scientists at Rice University and University of Texas MD Anderson Cancer Center in 2008. 3D cell culturing technology was later licensed and commercialized by Nano3D Biosciences.

Sources: en.wikipedia.org

Frequently asked questions

What is epitalon made of?

Epitalon is a synthetic tetrapeptide composed of four amino acids: alanine, glutamate, aspartate, and glycine. It is written as Ala-Glu-Asp-Gly. The free peptide has a molecular weight of about 390 daltons and is normally supplied as a lyophilized powder.

Is epitalon extracted from the pineal gland?

No. Epitalon is chemically synthesized, not extracted. It was designed as a short synthetic fragment conceptually related to larger pineal peptides studied in the same research tradition, particularly the extract known as epithalamin. The two are distinct materials with different compositions.

Why is epitalon described as a bioregulator?

The term bioregulator is used in this research tradition for short peptides proposed to influence gene expression or cell function. Epitalon is grouped with other synthetic short peptides under this label. The term reflects a proposed mechanism rather than an established drug classification.

What is epitalon?

Epitalon is a synthetic four-amino-acid peptide with the sequence alanine–glutamate–aspartate–glycine, also written AEDG. It was developed in Russian gerontology research and is studied for proposed effects on telomerase, melatonin regulation, and neuroendocrine function. It is not an approved pharmaceutical in the United States or the European Union.

Network