aspartimide is one of those subjects where the details matter more than the headlines. This page pulls together the background, the mechanisms, and the practical points readers ask about most.
Last reviewed on 2026-03-01. Where a claim depends on a specific study, the study is described rather than over-claimed.
Chemically, the molecule consists of four amino acid residues joined by three peptide bonds, with a free N-terminal amino group and a free C-terminal carboxyl group. Its molecular formula is C14H22N4O9, and its monoisotopic mass is approximately 390 daltons. The acidic glutamate and aspartate side chains give the peptide a net negative charge near neutral pH, a property that shapes its chromatographic behaviour and solubility profile. No disulfide bridges or other post-translational modifications are present, so the primary sequence alone defines the structure.
Most experimental work has been carried out in cell culture and animal models. Several reports describe changes in telomerase activity and proliferation in cultured cells, while rodent studies have examined lifespan, melatonin rhythm and reproductive endpoints. Human data remain limited, and much of the published clinical material consists of small trials with incomplete reporting of methods and controls. Whether the cell and animal findings translate into measurable effects in people is an open question, and the mechanistic basis of the reported telomerase changes is not fully established.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
Verification of research-grade material involves comparing a supplier chromatogram against an in-house reference, checking the observed mass against the calculated value, and where possible confirming residue order by tandem mass spectrometry or enzymatic peptide mapping. Purity claims should be read alongside the method used to obtain them, because detection wavelength and integration settings alter the result. Batch-specific data, rather than a generic grade statement, is the informative part of a certificate.
| Property | Value | Notes |
|---|---|---|
| Chemical class | Linear tetrapeptide | Four residues joined by three peptide bonds |
| Sequence | Ala-Glu-Asp-Gly | Commonly abbreviated AEDG |
| Molecular formula | C14H22N4O9 | Free acid form |
| Monoisotopic mass | Approximately 390 Da | Matches values reported from mass spectrometry |
| Net charge near neutral pH | Negative | Contributed by glutamate and aspartate side chains |
Epitalon is a synthetic linear tetrapeptide with the sequence alanine–glutamate–aspartate–glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and the calculated mass is approximately 390.35 g/mol. The compound is made by solid-phase peptide synthesis rather than extracted from tissue, although early work described it as a short fragment of a peptide fraction obtained from bovine pineal extract. In the research literature the spelling epitalon and the variant epithalone both appear, while AEDG is the standard code used in peptide nomenclature.
Several names circulate for the same molecule, including epitalon, epithalone, epithalamin tetrapeptide, and the sequence code AEDG. A CAS registry number, 307297-39-8, is commonly cited for it, though catalogue entries should be checked against supplier documentation because mislabelled records occur. In its usual form the peptide carries free amino and carboxyl termini and is neither glycosylated nor lipidated. Researchers distinguish the defined tetrapeptide from epithalamin itself, a crude pineal preparation containing many peptides that is not chemically characterised.
Material supplied for laboratory use is normally a lyophilised white to off-white powder that dissolves readily in water and in isotonic saline. Lyophilised cakes are hygroscopic and should be equilibrated to room temperature before opening to limit condensation on the solid. Solutions are typically prepared at milligram-per-millilitre concentrations and divided into single-use aliquots, because repeated freeze–thaw cycles degrade short peptides. Aqueous solutions are far less stable than the dry powder, and identity is usually verified by mass spectrometry alongside purity estimation from reversed-phase high-performance liquid chromatography.
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
On October 12, 2017, a group of four inmates attempted to escape from the Pasquotank Correctional Institution in Pasquotank County, North Carolina, United States, which resulted in the murders of two correctional officers and two prison employees. The four accused – Wisezah Buckman, Jonathan Monk, Seth Frazier, and Mikel Brady – were all arrested and charged with multiple counts of first degree murder. Brady, who masterminded the escape attempt, was found guilty and sentenced to death in 2019. Buckman and Monk were both convicted for their respective roles in the quadruple murder and sentenced to death in 2023 and 2025 respectively. Frazier was sentenced to life in prison without parole, after pleading guilty to the murders in 2025.
== Evolution == Aquatic plants have adapted to live in either freshwater or saltwater. Aquatic vascular plants have originated on multiple occasions in different plant families; they can be ferns or angiosperms (including both monocots and dicots). The only angiosperms capable of growing completely submerged in seawater are the seagrasses. Examples are found in genera such as Thalassia and Zostera. An aquatic origin of angiosperms is supported by the evidence that several of the earliest known fossil angiosperms were aquatic. Aquatic plants are phylogenetically well dispersed across the angiosperms, with at least 50 independent origins, although they comprise less than 2% of the angiosperm species. Archaefructus represents one of the oldest, most complete angiosperm fossils which is around 125 million years old. These plants require special adaptations for living submerged in water or floating at the surface.
B-DNA The "standard" or classical structural conformation of the DNA double helix in vivo, thought to represent an average of the various distinct conformations assumed by very long DNA molecules under physiological conditions. The B-form double helix has a right-handed twist with a diameter of 23.7 ångströms and a pitch of 35.7 ångströms or about 10.5 base pairs per full turn, such that each nucleotide pair is rotated 36° around the helical axis with respect to its neighboring pairs. See also A-DNA and Z-DNA.
Sources: en.wikipedia.org
== History == The name frappé ('punched', figuratively 'shaken') comes from French, and describes drinks chilled with ice. Beginning in the 19th century, a variety of cold coffee drinks named café frappé (à la glace) are documented, some similar to slushies and others more like iced coffee. It has been said that the Greek version of café frappé, using instant coffee, was invented in 1957 at the Thessaloniki International Fair. A representative of the Nestlé company, Giannis Dritsas, was exhibiting a new product for children. It was a chocolate beverage produced instantly by mixing it with milk and shaking it in a shaker. Dritsas' employee, Dimitris Vakondios, was looking for a way to have his usual instant coffee during his break but could not find any hot water, so, he mixed the coffee with cold water and ice cubes in a shaker. Nikos Bakounakis was the first to express doubts about this story in 2006, and further evidence was later presented by the magazine Gastronomos in 2013. Based on Nestlé’s newspaper advertisements from the period leading up to the 1957 Thessaloniki International Trade Fair, it appears that the product was already being promoted as "Nescafé frappe", either as coffee with ice cubes or as an iced shaken—as suggested by its name (frappé = shaken)—or stirred drink.
Nanohedron.com images of nanoparticles Lectures on All Phases of Nanoparticle Science and Technology Archived 29 August 2010 at the Wayback Machine ENPRA – Risk Assessment of Engineered NanoParticles EC FP7 Project led by the Institute of Occupational Medicine
== Function == This gene encodes a selenoprotein, which contains a selenocysteine (Sec) residue at its active site. The selenocysteine is encoded by the UGA codon that normally signals translation termination. The 3' UTR of selenoprotein genes have a common stem-loop structure, the sec insertion sequence (SECIS), that is necessary for the recognition of UGA as a Sec codon rather than as a stop signal. Studies in mouse suggest that this selenoprotein may have redox function and may be involved in the quality control of protein folding.
Sources: en.wikipedia.org
It is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, often abbreviated AEDG. The molecule is linear and contains no modified residues, so it is fully described by its sequence.
The compound came out of work on epithalamin, a peptide preparation derived from pineal tissue, conducted largely in Russian laboratories. Later studies in other countries examined it mainly in cell cultures and animal models.
The tetrapeptide sequence is a synthetic construct rather than a described circulating peptide. It was derived by analogy to peptide fractions obtained from tissue extracts, not isolated from blood or tissue as such.
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.