If you have been reading about reversed-phase HPLC and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-11-06. Where a claim depends on a specific study, the study is described rather than over-claimed.
Solubility is high in water, phosphate-buffered saline and normal saline, a pattern that follows from the two acidic residues in the chain. The peptide dissolves poorly in non-polar solvents such as hexane or chloroform. Stock solutions are often prepared in water first and then diluted into the buffer of interest. Because the molecule is small and hydrophilic, filtration through a low-protein-binding membrane is usually straightforward, and visible particulates are uncommon in freshly made solutions.
Identity and purity are established with reversed-phase high-performance liquid chromatography and mass spectrometry. The chromatogram shows the main peak and any truncated or oxidised by-products, while the mass spectrum confirms the expected 390 dalton mass. Amino acid analysis can corroborate composition when a sample's origin is uncertain. Counterion content, particularly residual trifluoroacetate from purification, is frequently reported alongside purity because it shifts the net mass of the solid.
Epitalon is a synthetic tetrapeptide whose sequence is alanine-glutamate-aspartate-glycine, written in single-letter code as AEDG. The four residues are joined by three peptide bonds, giving a linear backbone with no branching and no disulfide bridges. Its calculated molecular mass for the free form is approximately 390.3 daltons, a figure that rises when the compound is supplied as an acetate or trifluoroacetate salt. Because the chain is short, the molecule is defined entirely by its residue order rather than by any folded three-dimensional structure.
The compound is described in the literature as a derivative of epithalamin, a preparation obtained from bovine pineal tissue. Work on this peptide family was carried out mainly by a research group in Saint Petersburg beginning in the 1980s, and the substance was later registered for clinical use in Russia under the name Epitalon. Outside that region it is generally treated as a research chemical rather than an approved medicine. Statements about its biological activity rest on a relatively small number of studies, and independent replication remains limited.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilised and often hygroscopic |
| Solubility class | Freely soluble in water | Poor solubility in non-polar solvents |
| Typical storage temperature | -20 degrees Celsius or colder | Sealed, desiccated, protected from light |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Establishes purity and confirms mass |
| Common salt form | Trifluoroacetate or acetate | Counterion reported alongside purity values |
Analytical characterization of epitalon relies on standard peptide methods. Reverse-phase high-performance liquid chromatography is used to assess purity, and mass spectrometry confirms identity by checking the observed mass against the expected value near 390 daltons. Amino acid analysis can verify composition. Because the peptide is short and hydrophilic, it elutes early on many reverse-phase columns, so method development often requires ion-pairing reagents to achieve adequate retention and resolution from related impurities.
Storage and handling follow conventional peptide practice. Lyophilized epitalon is typically kept refrigerated or frozen, protected from moisture and light, and allowed to equilibrate to room temperature before opening to avoid condensation. Once dissolved, aqueous solutions are usually stored cold and used within a short period, since dilute peptide solutions can support microbial growth and may slowly degrade. The absence of cysteine and methionine reduces, but does not eliminate, oxidation concerns during long-term storage.
Regulatory status varies by country and is not harmonized. Epitalon is not an approved drug in major Western jurisdictions. In some countries it is sold as a research chemical, and in others it has appeared in products marketed for other categories. This inconsistent status means that purity, labeling accuracy, and documentation differ widely between suppliers, and verification of identity and purity through independent analysis is the usual way buyers assess a given lot.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, abbreviated AEDG. Its molecular formula is C14H22N4O9 and its calculated monoisotopic mass is approximately 390.35 daltons. The compound does not occur naturally as a free peptide; it is produced by solid-phase peptide synthesis. Because it contains two acidic residues and no basic residues, the neutral form carries a net negative charge at physiological pH. This charge profile influences how the peptide behaves in solution and during chromatographic analysis.
Laboratory-grade epitalon is typically supplied as a lyophilized powder. Purity is commonly assessed with reverse-phase high-performance liquid chromatography, often paired with mass spectrometry to confirm molecular identity. Amino acid analysis and peptide mapping can provide additional confirmation of sequence. Certificates of analysis for research materials frequently report purity above 95 percent, although the methods behind such figures vary between suppliers. The absence of a pharmacopeial monograph means that no single standardized assay defines the compound, so reported results depend on the analytical protocol chosen.
Storage recommendations center on limiting moisture, heat, and light. The dry powder is generally kept at minus 20 degrees Celsius, and some suppliers recommend minus 80 degrees for long-term archival. Once dissolved, solutions are usually aliquoted and frozen to avoid repeated freeze-thaw cycles, which can promote aggregation or degradation. Aqueous stability depends on pH and concentration, and buffered saline is often preferred over plain water for biological work. Stability data specific to epitalon remain limited, so general peptide-handling practices are applied by analogy rather than from product-specific validation.
Documentation accompanying research peptides usually includes a certificate of analysis listing the batch number, purity figure, and test methods applied. Buyers comparing suppliers should check whether the reported purity refers to chromatographic area or to a mass-balance calculation, because the two are not equivalent. Counter-ion content, residual solvents, and water content are sometimes omitted from such certificates even though they affect the actual peptide mass present. Independent verification through a second laboratory is the most direct way to confirm that a supplied material matches its label.
Purity assessment of peptide reagents normally relies on reversed-phase high-performance liquid chromatography. A gradient of acetonitrile in water with trifluoroacetic acid, paired with a C18 stationary phase, separates the target tetrapeptide from truncated sequences and deletion analogues. Detection at 214 nanometres exploits absorbance of the peptide backbone, since the molecule contains no aromatic residue. Results are expressed as a percentage of total peak area. Values above ninety-five percent are typical for research-grade material, although reporting conventions vary between suppliers.
Identity confirmation uses mass spectrometry, usually electrospray ionisation in positive mode or matrix-assisted laser desorption. The protonated free peptide produces a signal near three hundred and ninety-one daltons, while salt adducts shift that value slightly. Tandem mass spectrometry or amino acid analysis supplies sequence-level confirmation, which a single mass measurement cannot. Peptides containing aspartate can cyclise into succinimide intermediates that hydrolyse to isoaspartate isomers of identical mass. Because those isomers are difficult to separate chromatographically, identity and purity results carry more weight when interpreted together.
O-GlcNAc transferase OGTase O-linked N-acetylglucosaminyltransferase Uridine diphospho-N-acetylglucosamine:polypeptide β-N-acetylglucosaminyltransferase Systematic name: UDP-N-α-acetyl-d-glucosamine:[protein]-3-O-N-acetyl-β-d-glucosaminyl transferase
=== Market === The market for PFAS was estimated to be US$28 billion in 2023. The majority are produced by 12 companies: 3M, AGC Inc., Archroma, Arkema, BASF, Bayer, Chemours, Daikin, Honeywell, Merck Group, Shandong Dongyue Chemical, and Solvay. Sales of PFAS, which cost approximately $20 per kilogram, generated a total industry profit of $4 billion per year on 16% profit margins in 2023.
Mixed ligand complexes are common for amino acids. Well known examples include [Co(en)2(glycinate)]2+, where en (ethylenediamine) is a spectator ligand. In the area of organometallic complexes, one example is the half-sandwich complex Cp*Ir(κ3-methionine).
Sources: en.wikipedia.org
== External links == mTOR+protein at the U.S. National Library of Medicine Medical Subject Headings (MeSH) "mTOR Signaling Pathway in Pathway Interaction Database". National Cancer Institute. Archived from the original on 2013-03-18. Retrieved 2015-10-18. Overview of all the structural information available in the PDB for UniProt: P42345 (Serine/threonine-protein kinase mTOR) at the PDBe-KB.
A recent review article attributes these pathological states are caused by lower concentrations of protein and neurotransmitter synthesis within the central nervous system, as well as toxicity due to the buildup of branched-chain amino acids (BCAA) and branched-chain alpha-keto acid (BCKA). There are multiple mechanisms theorized for MSUD encephalopathy.
In the systemic circulation, veins serve to return oxygen-depleted blood from organs, and tissues to the right heart. From here it passes to the pulmonary arteries for the pulmonary circulation to return oxygen-rich blood to the left heart in the pulmonary veins, to be pumped back into the systemic circulation to complete the cycle. Veins have thinner walls than arteries, and a wider diameter that allow them to expand and hold a greater volume of blood. This gives them a functional role of capacitance that makes possible the accommodation of different pressures in the system. The venous system apart from the post-capillary venules is a high volume, low pressure system. Vascular smooth muscle cells control the size of the vein lumens, and thereby help to regulate blood pressure. The post-capillary venules are exchange vessels whose ultra-thin walls allow the ready diffusion of molecules from the capillaries. The return of blood to the heart is assisted by the action of the muscle pump, and by the thoracic pump action of breathing during respiration. Standing or sitting for a prolonged period of time can cause low venous return from venous pooling (vascular) shock. Fainting can occur but usually baroreceptors within the aortic sinuses initiate a baroreflex such that angiotensin II and norepinephrine stimulate vasoconstriction and heart rate increases to return blood flow. Neurogenic and hypovolaemic shock can also cause fainting.
The characteristics of seed lotus cultivars are a large number of carpels and seed sets as well as large seeds with better nutritional properties. Roots of these varieties are thin, fibrous, and do not form good rhizomes. The main popular cultivars for seed production in China are Cunsanlian, Xianglian 1, Zilian 2, Jianlian, Ganlian 62, and Taikong 36. The average yield of these cultivars in China is 1.05–1.9 t/ha (0.5–0.8 tons/acre) of dry seeds and weight of thousand seeds between 1,020 and 1,800 g (36 and 63 oz). Green Jade and Vietnam-Red are recommended cultivars for seed production in Australia.
Sources: en.wikipedia.org
Sealed lyophilised powder is normally kept at minus twenty degrees Celsius or below, away from light and moisture. Vials are allowed to reach room temperature before opening to limit condensation. Repeated warming and cooling of the same vial is discouraged.
Reversed-phase HPLC establishes purity and separation from related peptides, and mass spectrometry confirms the molecular mass. Amino acid analysis can verify residue composition. No single method proves identity on its own, so the results are read together.
Yes. Residual trifluoroacetate or acetate from purification adds mass and can shift the value obtained by certain assays. Purity figures are therefore meaningful only when the counterion form is stated. Reporting both peptide content and salt form gives a clearer picture.
The peptide contains four residues in the order alanine, glutamate, aspartate and glycine, abbreviated AEDG. The chain is linear and held together by three peptide bonds. Its calculated mass for the uncharged free form is about 390.3 daltons.