A practical reference on aspartimide: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
This page was last updated on 2026-05-31 and is reviewed periodically as new material appears.
Identity and purity of epitalon samples are normally established by reversed-phase high-performance liquid chromatography with ultraviolet detection near 214 nanometres, combined with mass spectrometry. The mass spectrum confirms the expected molecular ion and can reveal truncated or oxidised by-products. Amino acid analysis after acid hydrolysis verifies that the four residues are present in the expected ratio. Certificates typically report a purity figure taken from chromatographic peak area, expressed as a percentage of total integrated signal.
Lyophilised epitalon is generally held at minus twenty degrees Celsius in a sealed container kept dry and dark. Cooler conditions are sometimes recommended for long-term archives. The solid takes up moisture readily enough that repeated opening of a vial introduces water, so dividing a batch into smaller portions before storage lowers degradation risk. Aqueous solutions are less durable than the dry powder and are usually prepared shortly before use, then kept cold and shielded from light to slow hydrolysis and oxidation.
The compound is generally described as a synthetic analogue of a fragment isolated from a pineal gland extract. Researchers associated with the Saint Petersburg Institute of Bioregulation and Gerontology introduced it during the 1980s and 1990s while studying short peptides from animal tissue. The original extract, called epithalamin, is a heterogeneous mixture, whereas epitalon is a single defined sequence. That distinction matters because findings reported for the extract are not automatically findings about the pure tetrapeptide, and claims about broader biological effects remain a separate question from the chemical identity described here.
Residue composition is the property that most cleanly separates verified material from mislabelled samples. Alanine, glutamate, aspartate and glycine appear in that order from the N-terminus, and the two acidic residues sit in the middle of the chain. Because the peptide is short, it can be produced by solid-phase synthesis and characterised by mass spectrometry without ambiguity. Any reported sample whose measured mass departs substantially from 390 daltons is a different compound or a degraded mixture rather than epitalon.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by HPLC area | Higher grades are also offered |
| Primary analytical method | Reversed-phase HPLC, UV detection | Frequently paired with mass spectrometry |
| Confirmatory technique | Electrospray mass spectrometry | Observed mass compared with theory |
| Storage temperature | Minus 20 degrees Celsius, dry powder | Sealed, desiccated, protected from light |
| Solution handling | Prepare fresh before use | Hydrolysis proceeds in aqueous media |
Verification of a sample usually begins with reversed-phase high-performance liquid chromatography, which resolves the peptide from truncated sequences and other impurities and expresses purity as a percentage of total peak area. Mass spectrometry by electrospray ionisation or matrix-assisted laser desorption supplies an independent check, because the measured mass can be compared against the theoretical value for AEDG. Amino acid analysis or tandem mass spectrometry sequencing can confirm residue order. Each of these methods answers a different question: a purity figure does not establish identity, and an identity match does not establish how much of the material is intact peptide.
The molecule is a short, linear, hydrophilic peptide that dissolves readily in water or aqueous buffer. Its principal chemical liabilities are hydrolytic rather than oxidative, since it contains no cysteine, methionine, or tryptophan residues. The aspartate–glycine step is a recognised site for aspartimide formation under mildly acidic or basic conditions, generating isoaspartate and succinimide-related products over time. Desiccated lyophilised powder held at −20 °C is comparatively stable, whereas dilute solutions degrade faster and are best frozen as single-use aliquots rather than thawed repeatedly.
No pharmacopoeial monograph exists for this peptide, so quality rests on the supplier's internal specifications and on whatever independent testing a purchaser arranges. Certificates of analysis differ widely in which tests they report and in the limits applied. The counter-ion introduced during purification, commonly acetate or trifluoroacetate, changes the net peptide content of a given mass of powder, so two samples of equal weight may not contain equal amounts of the active sequence. Third-party laboratories can verify purity, identity, residual solvents, and counter-ion content for a fee, which makes documentation more informative than labelling.
The most frequently cited proposed action is induction of telomerase, the enzyme that adds repeat sequences to chromosome ends. Cell-culture work from the originating group reported higher telomerase reverse transcriptase expression and measurable telomere elongation in human somatic cells after exposure. How a four-residue peptide would reach nuclear gene regulation is not established, and no cell-surface receptor or uptake route has been identified. Additional reports describe changes in melatonin secretion, antioxidant enzyme activity and lipid peroxidation in aged animals, but these findings remain mechanistically unconnected to the telomerase observation.
Published evidence comes mainly from Russian-language journals and from a single research group, with small sample sizes and limited independent replication. A few laboratories outside that group have examined related peptides and reported weaker or absent telomerase effects, so the central claim is best described as contested rather than settled. Rodent studies report modest changes in some ageing markers and in survival, but designs vary and control conditions are often sparse. No large randomised trial in humans has been published, and long-term safety data in healthy populations are correspondingly thin.
Epitalon is a synthetic tetrapeptide with the sequence alanine-glutamate-aspartate-glycine, commonly abbreviated AEDG. It was designed at the St. Petersburg Institute of Bioregulation and Gerontology as a short, chemically defined analogue of epithalamin, a fraction obtained from bovine pineal tissue. Small peptide bioregulators of this type formed a long-running line of work there from the 1980s onward. Because the molecule is produced by solid-phase synthesis rather than extraction, its composition is exact and its purity can be measured directly.
== Medical uses == Amitriptyline/chlordiazepoxide is used for the treatment of moderate to severe depression associated with moderate to severe anxiety. It has shown to be more effective in treating symptoms of anxiety, irritability, and hostility in patients with comorbid depression and anxiety than amitriptyline alone. It also has a quicker onset time than either amitriptyline or chlordiazepoxide on their own.
== Research == Vedolizumab eventually completed a number of phase III clinical trials for Crohn's Disease and Ulcerative Colitis (GEMINI I, GEMINI II, and GEMINI III) that demonstrate that vedolizumab is an effective and well tolerated drug. The results of the GEMINI 1 and GEMINI 2 randomized, placebo controlled multicenter trials of induction and maintenance therapy in Crohn's disease and ulcerative colitis have been published. An additional clinical trial, GEMINI LTS (Long-term Safety), was completed in October 2017.
The sector is composed of both "dedicated" AI companies, those for which AI is the primary revenue source, and "diversified" companies, which offer AI products and services as part of a broader commercial offering. In 2024, 56% of identified firms were dedicated and 44% were diversified, with the share of diversified companies continuing to grow year-on-year, reflecting the increasing integration of AI across the wider economy. The vast majority (95%) of all identified AI companies are small and medium-sized enterprises (SMEs), with micro-businesses (fewer than 10 employees) accounting for 70% of the sector.
== Usage == This technique can be used to identify the genomic footprint of inbreeding in conservation programs, as organisms that have undergone recent inbreeding will exhibit long runs of homozygosity. For example, the step-wise reintroduction strategy of the Alpine Ibex in the Swiss Alps created several strong population bottlenecks that reduced the genetic diversity of the newly introduced individuals. The effect of inbreeding in the resulting sub-populations could be studied by measuring the runs of homozygosity in different individuals. In clinical laboratory testing, the detection of ROH in itself does not indicate a particular genetic disorder but indicates an increased risk of autosomal recessive inherited diseases. As ROHs smaller than 3 Mb spread throughout the genome are common even in outbred populations, these segments were usually thought to not be important enough to report. Large ROH can be indicative of uniparental isodisomy with follow-up testing to rule out false positives, there is currently no consistent reporting standards among different laboratories. ROH can be used to detect the possibility of incest in humans.
Sources: en.wikipedia.org
Some common side effects include burning and stinging sensations. Colour change of the skin, bump formation on the skin and additional hair growth could also occur. It is recommended that a doctor be consulted if these side effects persist or become worse. Some severe side effects are severe rash, swelling of the skin, and skin infection. Rare but serious allergic reactions, also known as anaphylaxis, can also occur. In the event that any of these side effects are encountered, patients are advised to approach a doctor immediately. Adverse effects after a long-term use of topical hydrocortisone include adrenal gland disorders. This problem can be more severe when excess topical hydrocortisone are used for a prolonged period of time. Other adverse effects include blurry vision, dizziness, fainting, unusual heartbeat, thirsty sensation, frequent urination, and fatigue. It is recommended that a doctor be informed if any of these symptoms occur. The impact of ingestion (eating) of such products has not been reported systematically, but a case report published in 2022 suggests this can lead to hospitalization and be potentially life threatening.
=== Diabetes === There are numerous theories as to the exact cause and mechanism in type 2 diabetes. Central obesity is known to predispose individuals for insulin resistance. Abdominal fat is especially active hormonally, secreting a group of hormones called adipokines that may possibly impair glucose tolerance. But adiponectin, an anti-inflammatory adipokine, which is found in lower concentration in obese and diabetic individuals has shown to be beneficial and protective in type 2 diabetes mellitus (T2DM). Insulin resistance is a major feature of diabetes mellitus type 2, and central obesity is correlated with both insulin resistance and T2DM itself. Increased adiposity (obesity) raises serum resistin levels, which in turn directly correlate to insulin resistance. Studies have also confirmed a direct correlation between resistin levels and T2DM. And it is waistline adipose tissue (central obesity) which seems to be the foremost type of fat deposits contributing to rising levels of serum resistin. Conversely, serum resistin levels have been found to decline with decreased adiposity following medical treatment.
=== Pyrolysis gas chromatography === Pyrolysis–gas chromatography–mass spectrometry is a method of chemical analysis in which the sample is heated to decomposition to produce smaller molecules that are separated by gas chromatography and detected using mass spectrometry. Pyrolysis is the thermal decomposition of materials in an inert atmosphere or a vacuum. The sample is put into direct contact with a platinum wire, or placed in a quartz sample tube, and rapidly heated to 600–1000 °C. Depending on the application even higher temperatures are used. Three different heating techniques are used in actual pyrolyzers: Isothermal furnace, inductive heating (Curie point filament), and resistive heating using platinum filaments. Large molecules cleave at their weakest points and produce smaller, more volatile fragments. These fragments can be separated by gas chromatography. Pyrolysis GC chromatograms are typically complex because a wide range of different decomposition products is formed. The data can either be used as fingerprints to prove material identity or the GC/MS data is used to identify individual fragments to obtain structural information. To increase the volatility of polar fragments, various methylating reagents can be added to a sample before pyrolysis. Besides the usage of dedicated pyrolyzers, pyrolysis GC of solid and liquid samples can be performed directly inside Programmable Temperature Vaporizer (PTV) injectors that provide quick heating (up to 30 °C/s) and high maximum temperatures of 600–650 °C. This is sufficient for some pyrolysis applications.
Sources: en.wikipedia.org
The usual approach is reversed-phase HPLC with ultraviolet detection, reported as a percentage of total peak area. Mass spectrometry is used alongside chromatography to confirm identity rather than purity alone.
The dry powder is commonly kept at minus twenty degrees Celsius, desiccated and away from light. Solutions are generally prepared fresh because they break down faster than the solid form.
Tandem mass spectrometry or enzymatic peptide mapping can establish residue order. A single intact mass value indicates composition and molecular weight but not always the precise arrangement of residues.
It is a four-amino-acid peptide built from alanine, glutamate, aspartate and glycine in that order. Its formula is C14H22N4O9, and it is made by chemical synthesis rather than extracted from tissue. The synthetic peptide is a single defined molecule, unlike the pineal extracts it is often compared with.